Electrical control and measurements >

MVT101 · THREE PHASE VOLTMETER



THREE PHASE VOLTMETER



MVT101 three-phase voltmeter with alarms: protects equipment against overvoltage, undervoltage and phase loss. Up to 500 VAC, 4 modes.

Product type: Three-phase voltmeter with alarms
Installation: DIN rail or wall
Measurement: RMS value of each phase, R-S-T / L1-L2-L3
Alarms: Overvoltage, undervoltage and phase loss

Features

  • ✓Shows the RMS value of each phase: the phase is changed with the UP and DOWN keys
  • ✓Overvoltage and undervoltage alarms with programmable values
  • ✓Phase loss alarm
  • ✓4 operating modes: display only, automatic, timed and latched
  • ✓Programmable number of fault cycles before acting: 1 to 999, minimum response 20 ms
  • ✓Green or red phase LEDs and OVER / UNDER alarm LEDs
  • ✓Plug-in connectors
Supply
110 … 230 VAC
Outputs
2 x SPST 5A
Measurement
L1-L2-L3 · up to 500 VAC
Mounting
DIN rail or wall

How it works

  1. 1The three phases to be monitored are connected before powering the unit.
  2. 2When powered, the display shows the voltage of one phase and its LED lights up; UP and DOWN switch to L1, L2 or L3.
  3. 3Holding ENTER for 3 to 5 seconds gives access to the overvoltage and undervoltage alarms, the fault cycles and the operating mode.
  4. 4If a phase leaves the range for the programmed cycles, the corresponding alarm output acts and the display shows the first phase that failed.

Frequently asked questions

Which operating modes does it have?

Four: 1 display only, 2 automatic, 3 timed (0.1 to 99.9 s) and 4 latched, reset with the ENTER key.

Up to what voltage does it measure?

Up to 500 VAC between phases.

Does it detect the loss of a phase?

Yes. In addition to the overvoltage and undervoltage alarms, it has a phase loss alarm.


General information

Reference MVT101  (110 … 230 VAC)
Series M · DIN rail or wall
Product type Three-phase voltmeter with alarms

Electrical specifications

Supply 110 … 230 VAC · 50/60 Hz
Outputs 2 x SPST 5A: overvoltage and undervoltage alarm

Measurement

Input Three-phase R-S-T / L1-L2-L3, three-wire
Maximum 500 VAC
Reading RMS value of the selected phase

Alarms and modes

Alarms Overvoltage, undervoltage and phase loss
Fault cycles 1 to 999 · minimum response 20 ms
Modes 1 display only · 2 automatic · 3 timed 0.1–99.9 s · 4 latched (ENTER reset)

Indications

L1, L2, L3 LEDs Green: phase correct · red: phase in fault
OVER / UNDER LEDs Orange: out of range · red: alarm active

Housing and mounting

Fixing DIN rail or wall
Connection Plug-in connectors




Automatismos.com