For machine builders we design and manufacture the machine's control electronics in Barcelona: standard units with the function you need, sequencers with HMI display and our own electronic boards. We can fit your machine with a capacitive HMI touch screen driven by a sequencer (a small PLC), at a much lower cost than a PLC with an HMI display. Today 60 % of our production is customised units for manufacturers and installers.
The touch screen is the Modbus master: it reads the MSP800 programmer, the SCE485 counter, the STD485 timer and the XVE485 totalizer over a single 2-wire RS485 cable.
Featured product
MSP800 programmer with HMI display
A single DIN-rail unit combines PLC, sequencer and cam timer: 8 inputs, 8 outputs, real-time clock and Modbus communication to connect it to a touch screen.
| 8 I / 8 Ooptocoupled inputs · NO 5 A outputs | ModbusRS232 / RS485 | 5" · 7" · 10"HMI touch screen | Clockreal-time |
| Program | Factory-loaded to your project (custom firmware) |
| Display | OLED on the unit and connection to an HMI display |
| Supply | 100 – 240 VAC |
| Format | Modular DIN-rail housing, 90 × 62.5 × 70 mm, with plug-in connectors |
| Machine or installation | What to control | Unit |
|---|---|---|
| Machine with a multi-step cycle | Switch each output on in its step, by time or on an input (electronic cam timer) | |
| Machine that starts on power-up | Fixed 2-output cycle loaded at the factory | |
| Mixer, drum, reversible belt | Direction reversal with a pause between directions | |
| Machine with several chained times | Four timings with their pauses | |
| Signalling and beacons | Flashing with solid-state output | |
| 48 × 48 control panel | Timer, counter or controller with your machine's logic | |
| Machine with mechanical timers | Electronic replacement with normal or inverted clutch | |
| Machine with PLC, display or SCADA | Times, counts and states over RS485 Modbus | |
| Temperature to the PLC | 0 – 10 V or 4 – 20 mA signal from the probe | |
| Compact 72 × 36 panel | Timing and counting with little front-panel space | |
| Machine motors | Phase failure and overload | |
| Maintenance | Running hours |
Does your machine need something that is not in the catalogue?
Tell us about your control sequence and wiring diagram: we adapt a standard unit, program a sequencer or design your product's electronic board.
Custom solutions: Sequencers with HMI display · Custom units · Custom electronic boards
Can a sequencer replace a small PLC?
Yes. MSP programmers combine PLC, sequencer and cam timer in one DIN-rail unit, with the application loaded at the factory to your project. They also replace cascaded timers and mechanical cam timers.
Which displays can be connected?
The MSP800 connects over Modbus to 5", 7" or 10" capacitive touch screens. Non-standard formats are also available depending on the application.
Do you build short runs of your own electronics?
Yes. We design and manufacture OEM electronic boards in short runs, with our own SMD assembly, in Barcelona.
See also: Sequencers with HMI display · Custom units · Custom electronic boards · Price list
Food industry
Construction
Cranes
Compressors
Discharge pumps
Vacuum pumps
Boiler safety
Irrigation and purification
Textile
Lighting
Air conditioning control
Machine builders (OEM)
Sequencers with HMI display
Custom units
Custom electronic boards
+ Sectors
